| Operation power | AC100 to 240V ±10% 50/60Hz |
|---|---|
| Power consumption | 16W 38VA |
| Input | • Sensor input: 2 systems NPN open collector input or PNP open collector input (selectable) (Note 1) Active input level: LO side/HI side selectable (Note 2) • Conditions for the sensor to connect: Residual voltage at ON: 4V or less, Leakage current OFF: 1mA or less Load current of 15mA or more • Minimum input time: 0.5ms (Note 3) |
| Operation modes | AND operation, CLOCK AND operation |
| Timer operations | ON-delay, OFF-delay, One-shot, None |
| Timer time | 0.0 to 9.9s |
| Output | • NPN open collector output (photocoupler isolated) Rating: 30VDC 100mA or less. Residual ON voltage: 1.5V or less. Response time: 1ms or less • Relay output Contact: 1C, Rating: 250VAC 2A or less, Response time: 10ms or less |
| Power supply for sensor | 24VDC / 12VDC selectable (Note 4) • 24VDC ±10% (400mA or less), 12VDC ±10% (150mA or less) |
| Indicator | 7-segment LED, 2-digit indicator, red |
| Indicator | POWER: Power indicator (green LED), OUTPUT: Operation indicator (orange LED) |
| Connection method | Terminal block (screw: M3, terminal width: 6.4mm) |
| Mounting method | DIN rail (35mm) or M4 screws (mounting with 2 holes) |
| Weight | Approx. 260 g |
| Material | Case: PC, Terminal block cover: PC |
| Accessory | Instruction manual |
| Ambient temperature | -10 to +55°C (non-freezing) |
|---|---|
| Ambient humidity | 35 to 85%RH (non-condensing) |
| Protection | IP20 |
| Operating environment | Indoor use, Overvoltage category: II, Pollution level: 2, Maximum altitude: 2000m |
| Vibration | Compliant with IEC61131-2 5-8.4Hz (double-amplitude 3.5mm) 8.4-150Hz (1G) X, Y, Z directions, each 2 hours |
| Impact resistance | Compliant with IEC61131-2 147m/s2 (15G) X, Y, Z directions, 3 times each |
| Dielectric withstand voltage | 2kV AC, 1 minute (Note 5) |
| Insulation resistance | 500V DC, 20MΩ or more (Note 5) |
Note 1: Selection of NPN/PNP type for sensor input is common to the two systems.
Note 2: Active input level can be individually set for the two systems.
Note 3: Minimum time necessary for acquiring input signals
Note 4: Voltage selection is common to the two systems.
Note 5: Between the primary power and the case, between the primary power and the sensor power, between the primary power and F.G., between the primary power and the relay output, between the primary power and NPN open collector output