Home > Products Info > Photo Sensors with Built-in Amplifier > UM series
| NE2-2 | CN-T100MR | GKM (oil) | GKM (water) | GKM (PET) | UX | ASG | GN-C | UM | UM side-on | Mini-G |
| VS-S | GA | Middle-G | NT30F | CX | DLZ | GM | LD-M/S | LD-MX5R | PF | GA-MT1R | NE-DC | NEF |
UX series
UX series - photo
 
  • Super-miniature
    Type with built-in amplifier photoelectric sensor that can be installed by fiber sense
  • First introduction in the world for Side-view type(thread size: M5 type).
    A side-view type of an installation is the first introduction in the world.
  • Super-space-saving
    It is possible to install it without taking space by the fiber sense.
  • Long distance detection up to 1m
    A straight type of through-beam achieves the long distance of 1000mm.
  • An environmental specification is preeminent.
    High solidity and durability are performed by a strong body made of the stainless steel.
  • It is strong also in the medicine.
    Polysulfone lens is adopted as chemical resistance.
  • High operativeness
    The diffuse reflection type is equipped with sensitivity adjustment.
    (Model: UX-R5V and UX-R5VPN)
 
DIMENSIONS OUTPUT CIRCUIT PDF DXF
Type
Type Models Detection distance
Through beam Straight type UX-T100D NPN output 1000mm
UX-T100DPN PNP output
Side view type UX-T50DS NPN output 500mm
UX-T50DSPN PNP output
Diffuse reflection Straight type UX-R2 NPN output 3~20mm
UX-R2PN PNP output
UX-R3 NPN output 3~30mm
UXR3PN PNP output
UX-R5 NPN output 3~50mm
UX-R5PN PNP output
UX-R5V NPN output
UX-R5VPN PNP output
 
Specifications
Ratings and performance Detection method Through beam Diffuse reflection
Type Straight type Side view type Straight type
Models NPN output UX-T100D UX-T50DS UX-R2 UX-R3 UX-R5 UX-R5V
PNP output UX-T100DPN UX-T50DSPN UX-R2PN UX-R3PN UX-R5PN UX-R5VPN
Detecting distance 1000mm 500mm 3~20mm 3~30mm 3~50mm 3~50mm *1
Standard detection object ø4mm Opaque ø5mm Opaque 100 × 100mm white paper
Thread size(screw size) M5 × 5 M6 × 75
Power supply DC12~24V±10%      ripple 10% or less
Current consumption Transmitter: .15mA or less.
Receiver: 15mA or less
20mA以下
Output mode Open collector output
NPN output   ratings: Sink current: 80mA DC30V or less
PNP output   ratings: Source current: 80mA DC30V or less
Operation mode Dark on Light on
Response time 0.5ms or less
Operating angle 2° (receiver side) 10° (receiver side)
Specification Light source Red LED (630nm) Red LED (625nm) Infrared LED (870nm)
Indicator Operation: Orange LED, Stability: Green LED
Sensitivity adjustment SENS.VR *1
Short protection Built-in
Material Case, Nut and Washer: SUS303, Lens: Polysulfone
Connected method Flying lead outer diameter ø2.8   length   2m.
Transmitter: 0.15sq×2 core
Receiver: 0.15sq×3 core
0.15sq×3 core
Mass Transmitter: 30g, Receiver: 30g 30g
Accessory Screw driver
Environmental performance Ambient light 3,000lx or less
Ambient temperature -25 to +55°C (non-freezing)
storage :-30 to +70°C (non-freezing)
Ambient humidity 35 to 85%RH (non-condensing)
Protective structure IP67
Vibration 10-55Hz/ 1.5mm amplitude, 2 hours in X.Y.Z direction for each
Shock 500m/s2, 3 times each in 3 directions
Dielectric withstanding 500VAC for 1 minute
Insulation resistance 500VDC, 20MΩ or higher
*1 : Please use the driver of the attachment and operate it with 8mN・m or less when you rotate the potentiometer.
go to page top
  Copyright © TAKENAKA ELECTRONIC INDUSTRIAL CO.,LTD. All Rights Reserved.