 Model |
LED Color sensor-Amplifier unit |
| CS-D3 |
CS-D3PN |
| Detection method |
Time sharing spectrum
measurement by red/green/blue LED |
| Dtection range |
Depending on fiber
unit |
| Detection spot |
Depending on fiber
unit |
| Power supply |
12-24V DC 10% Ripple
10% or less |
| Power consumption |
1.6W or less |
| Response time |
Normal mode (NML):1msec
or less
Average value mode (AVE):5msec or less |
| Output |
NPN open collector |
PNP open collector |
| Rating |
Sink current 100mA (30V DC) Max. |
Source current 100mA (30V DC)
Max. |
| External input |
Non voltage input Input time:60msec
or more |
| Standard color |
3 colors(selected by Bank changeover
switch) |
| Tolerance range |
9 degrees |
| Discrimination |
COL(Color element) / C + Y(Color element
+ Brightness) |
| Teaching |
Auto(AUT)/Manual(MAN)/Mix(Mix) |
| Timer |
Non(NON)/Off-delay(OFD) Approx. 50msec |
| Light source |
Red/Green/Blue LED |
| Receiving element |
Photodiode |
| Indicator |
| Power indicator(RUN): |
|
Yellow LED-Lights when poweris supplied Flashes under
teaching |
| Operation indicator(OP.): |
|
Orange LED-Lights when output is issued Flashed under
mix teaching |
| Stability indicator(STB): |
|
Green LED Lights for stable detection Flashes under
auto teaching |
| Error indicator(ERR): |
|
Red LED-Lights for teaching error Flashes for sensor
trouble |
|
| Circuit protection |
Short circuit/Reverse connection of
power supply protection built-in |
| Case Protection |
IP65(with fiber unit attached) |
| Materials |
Case: Heat-proof ABS Cover: Polycarbonate |
| Connection |
Lead wire (Outer dia. ø4.5)
0.2sqf4core 2m length |
| Weight |
100g or less |
| Operating Temperature |
-10 ~ +55°C (without condensation) |
| Operating humidity |
35 to 85% RH |
| Vibration protection |
10 to 55Hz Multiple amplitude 1.5mm
XYZ directions/each 2 hours |
| Shock protection |
500m/S2(approx.50G) XYZ
directions each 3 times |
| Voltage protection |
AC 1000 V for 1 minute |
| Insulation resistance |
500V DC mega 20Ω or more |
