| Detection method | Through beam |
|---|---|
| Detecting distance | 100m |
| Detectiing object | dia.28mm or more |
| Power Supply | 12-24VDC ±10% Ripple 10% or less |
| Current consumption / Power consumption | Transmitter: 30mA or less / Receiver: 35mA or less |
| Output mode | NPN open collector output Rating: Sink current 200mA (30VDC) or less |
| Operation mode | Light ON/Dark ON (selectable with switch) |
| Light monitor | NPN open collector output Rating: sink current 200mA (30VDC) or less |
| Alarm output*1 | NPN open collector output Rating: Sink current 200mA (30VDC) or less |
| Response time | 5ms or less |
| Light source | Infrared LED (wave length 910nm) |
| Indicator | (Transmitter) P.L: Power indicator (green LED) … Illuminated when power on OP.L: Monitor indicator (red LED) … Illuminated when emit light normally (Receiver) OP.L: Operation indicator (red LED) …Illuminated when output on LEVEL: Level indicator (three level display) LEVEL1: yellow LED illuminated when light intensity of about twice as much as operation level is detected. LEVEL2: yellow LED illuminate |
| Switch (SW) | Light ON/Dark ON Remove the case lid of the receiver Light ON … Output at light receiving selector switch provided to access the switch. Dark ON … Output at light blocking |
| Materials | Case: Zinc die cast |
| Connection | Terminal block (screw: M3.5, width: 8.1mm) |
| Weight | Transmitter: Approx. 800g Receiver: Approx. 800g |
| Accessories | Operation manual, Mounting bracket |
*1 When the light intensity is LEVEL 1 or lower, the alarm is output (yellow LED turns off).
| Ambient light (on light receiving surface) | 50,000 lx or less (incandescent lamp) |
|---|---|
| Ambient temperature | -25 - +55 ℃ (Non-freezing) |
| Storage temperature | -40 - +70 ℃ (Non-condensing) |
| Ambient humidity | 35 - 85%RH (Non-condensing) |
| Protective structure | IP66 |
| Vibration | 10-55 Hz / 1.5 mm double amplitude / 2 hours each in 3 directions |
| Shock | 1000 m/s2 / 3 times each in 3 directions |
| Dielectric withstanding | 500 VAC for 1 minute (between input/output and case) |
| Insulation resistance | 500 VDC, 20 MΩ or higher |
*1 When the light intensity is LEVEL 1 or lower, the alarm is output (yellow LED turns off).