ASW-SG85F

Rating/Performance/Specification

Applicable Wafer 8 inch 
normal mode : transmittance: 30% or less
latch mode : transmittance:70% or less
Number of channels 25ch
Wafer pitch 6.35mm
Detection method Through beam
Comb Replaceable
Power supply DC24V ±10% ripple 10% or less
Current consumption 1.8W or less
Operation mode Dark ON
Normal mode / Latch mode selectable(with switch)
ON/OFF when trouble
Output mode NPN open collector
Rating : sink current 30VDC or less, 20mA or less
Response time 12ms or less
Light source Infrared LED (870nm)
Light emission
inhibit input / re-teaching
(self diagnosis function)
Open collector input or contact input Light emission inhibit ON: 1.5V or less OFF: 4V or more
Normal mode:Light emission inhibit at ON.
Re-teaching at OFF.
Latch mode : Reset the latch output and inhibit light emission at ON.
Re-teaching at OFF.
Output inhibit input Open collector or contact input
Output inhibit ON : 1.5V or less OFF : 4V or more
Connection Attached cable with connector (Fujitsu FCN-361J040-AU)
Cable length : 3m
Material Sensor unit : Polycarnonate
Housing : Aluminum
Mass Approx. 390g
Accessories Operation manual

Environmental Specification

Ambient temperature -10 to +55℃ (non-freezing)
Ambient humidty 35 to 85%RH (non-condensation)
Protective structure IP40
Ambient illumination 1500 lx or less
Vibration 10 to 55Hz double amplitude 0.5mm X, Y, Z directions, 2 hours each
Shock 300m/s2 X, Y, Z directions, 3 times each