DLN-S10RVP-J

Specification

Type Short range / PNP model
Detection method BGS (Background suppression) / FGS (Background recognition)
Detecting distance 10 to 100mm
Setting distance 30 to 100mm (*1)
Set distance at factory 100mm (*2)
Power supply 12 to 24VDC, class 2 / Ripple 10% or less
Current consumption 18mA or less
Operation mode Light ON / Dark ON selectable (by switch)
Output mode NPN open collector output / Load current 100mA (30VDC, class 2) or less / Residual voltage:1V or less
PNP open collector output / Load current 100mA (30VDC, class 2) or less / Residual voltage:2V or less (*3)
Light source (wavelength) Four-element (AlGalnp) LED (660nm)
Response time 0.5ms or less
Hysteresis 5% or less
Indicators Operation indicator: orange LED / Stability indicator: green LED
Adjustment volume Distance setting volume (5-turn endless potentiometer)
Selectors BGS / FGS selector, Light ON / Dark ON selector
Circuit protection Output short circuit / Reverse connection / Surge protection
Anti interference Automatic mutual interference prevention function (*4)
Material Case : PBT, Lens : Polycarbonate
Connection M8 4 pin connector (Cable with connector is separately available.)
Weight 6g
Accessory Instruction manual, screw driver (Mounting bracket: seperately available)

Note:The distance is adjusted to the "Set distance at factory" for each corresponding model by using a white paper, at which the sensor has optimum sensitivity.
*1 When using 50×50mm white paper for short range models and 100×100mm white paper for middle range models.
*2 The detection distance becomes longer than the specification when the distance setting volume is turned clockwise from the factory set position.
*3 Do not use the NPN and the PNP outputs simultaneously.
*4 Check the operation when two sensors are installed adjacently. The mutual interference prevention function may not work properly depending on conditions of installation or detecting objects.

Environmental specification

Ambient light 5,000 lx or less
Ambient temperature -25 to +55℃
(Storage temperature : -40 to +70℃) (non-freezing/non-condensing)
Ambient humidity 35 to 85%RH (non-condensing)
Protective structure IP67
Vibration 10 to 55Hz double amplitude / 1.5mm 2 hours each in 3 directions
Shock 500 m/s2 3 times each in 3 directions
Dielectric withstanding 1,000 VAC 1 minute
Insulation resistance 500 VDC megger, 20MΩ or more