Detection method | Identifying brightness |
---|---|
Light sensitivity | DC lighting 10 to 10000lx (white LED) / pulse lighting depends on conditions |
Standard detection target | Light source that emits visible light and near-infrared light / DC lighting / pulse lighting |
Power supply | 12 to 24 VDC, Ripple 10% or less |
Current consumption | 500mW or less (20mA or less at 24V) |
Standard light wavelength | 400 to 900nm |
External teaching input | No-voltage input (contact / no-contact) (During target value setting mode teaching only) |
Output | NPN mode : NPN open collector output Rating:Sink current 50mA (30 VDC) or less / Residual voltage 2V or less PNP mode : PNP open collector output Rating:Source current 50mA (30 VDC) or less / Residual voltage 2V or less |
Operation mode | Light ON / Dark ON (operation mode selectable) |
Timer | ON delay / OFF delay Delay timer : 0ms to 999ms (set in millsecond) |
Response time | 0: 1ms / 1: 10ms / 2: 100ms / 3: 1000ms *1 |
Indicator | Operation indicator: "OP"LED (orange) lights when output is issued Basic operation setting mode indicator:"SP"LED (red) lights up during basic operation setting |
Display | Function display (orange) / Numeric display 3-digits (0 to 999, red) |
Operation switch | [+] and [-] push button switches:setting selection / reference light level teaching / parameter change Selector switches: RUN / SELECT / SET selection |
Protection circuit | Power reverse connection / Output short-circuit protection / Output reverse connection |
Material | Polycarbonate |
Wiring | Attached cable (o.d.φ3.7), 0.2mm2 x 4-cores, 2m |
Weight | Approx. 60g (Cable 2m, including mounting bracket) |
Accessory | Mounting bracket / Instruction manual |
* 1 Detection is enabled 2 seconds after power is applied.
* 2 Fiber optic cable is optionally available.
Recommended fiber optic cable: FT-105BC-CS (core diameter φ1.5)
Ambient temperature | -25 to +55℃ (no freezing) |
---|---|
Ambient humidity | 35 to 85%RH (no condensation) |
Protective structure | IP40 |
Vibration | 10 to 55Hz / 1.5mm double amplitude / 2 hours each in X, Y and Z directions |
Shock | 500 m/s2 / 3 times each in X, Y, Z directions |
Dielectric withstanding | 1000 VAC for 1 minute |
Insulation resistance | 20MΩ or more with 500 VDC Megger |